MASSEY FERGUSON TE-20 Series Factory Tractor Workshop Manual | PDF Download

MASSEY FERGUSON TE-20 Series Factory Tractor Workshop Manual | PDF Download

Models covered in this Workshop Manual:

• Massey Ferguson TE-A20
• Massey Ferguson TE-C20
• Massey Ferguson TE-D20
• Massey Ferguson TE-E20
• Massey Ferguson TE-F20
• Massey Ferguson TE-H20

Engines covered in this Workshop Manual:

• 1850cc Petrol
• 2092cc Diesel

Below is a detailed list of topics covered in the Massey Ferguson Workshop Manual:

• Specification
• Specifications for 1850cc Petrol Engine (Clearances, Torque tightening etc.)
• Specifications for Vaporizing Oil Engine (Clearances, Torque tightening etc.)
• Specifications for 2088cc Petrol Engine (Clearances, Torque tightening etc.)
• Specifications for 2092cc Diesel Engine (Clearances, Torque tightening etc.)
• Specifications for Lamp Oil Engine (Clearances, Torque tightening etc.)
• Petrol Engine Rebuild Instructions for TE-A20 and TE-C20
• Lubrication System
• Oil Distribution
• The Oil Pump
• The Oil Filter
• Overhaul of Cylinder Head Assembly
• Camshaft and Timing Mechanism
• Engine Removal and replacement
• Sleeves, Pistons & Connecting Rods
• Diesel Engine Rebuild Instructions for TE-F20
• Introduction
• Lubrication System
• Overhaul of Cylinder head Assembly
• To remove Valve Springs and Collars with Cylinder Head Fitted
• To Dis-assemble and Re-Assemble Rocker and Decompression Shaft Assembly
• Renewing Valve Rocker bushes
• Renewal of Pre-Combustion Chamber Lower Half
• Removing and Replacing Valve Guides
• Valve Seats
• Tappets and Push Rods 
• Camshaft and Timing Mechanism
• Cylinder Inserts, Pistons, Connecting Rods and Liners
• Crankshaft and Main bearing Housings
• Cooling System
• Cooling System Petrol Engine
• Cooling System on Vaporizing Oil Engine TE-D20
• Cooling System on Lamp Oil Engine TE-H20 
• Cooling System on Diesel Engine TE-F20
• Fuel System
• Petrol Tank
• Tank Mounting
• Remove the Tank
• Function of the Petrol Valve and Sediment Bowl
• Petrol Valve and Sediment Bowl Assembly
• Function of the Air Cleaner
• Air Bleed to Induction Manifold -Engine Ventilation
• The Schebler " Marvel" Carburetor Tractors type TE-20
• The Zenith Carburetor 24T-2Tractors Type TE-A-20
• Fuel System for Tractors and Type TE-D20 Vaporizing and TE-H20 Lamp Oil
• Identification of Carburetors 
• Fuel System Fault Table 
• Fuel System for Diesel Engine TE-F20
• Governor Control
• Dismantling Instructions
• To Remove Throttle Hand Lever
• To Replace Throttle Hand Lever
• To Remove Throttle Rod Assembly
• To Replace Throttle Rod Assembly
• To Remove and Dismantle Governor
• To Remove Governor Shaft
• To Replace Governor Shaft
• Governor Adjustments
• Governor Control and Throttle Linkage
• Principle of the Pneumatic Governor
• Speed Setting
• Maximum Speed Adjustment
• Engine Idling Speed
• Prevention of Engine Surging
• Minimum Speed Adjustment in conjunction with the Governor Anti·Surge Device.
• Precautions to be taken against Fuel leaking into the Governor.
• Servicing the Governor
• Electrical System
• Specification and test data 6 Volt System
• Batteries
• Dynamo
• Starter Motor
• Stater Motor Switch
• Distributor - Petrol, Vapourizing Oil, Lamp Oil
• Ignition Coil - Petrol, Vapourizing Oil, Lamp Oil
• Ignition Warning Light 
• Control Box
• Servicing Instructions 12 Volt System
• Batteries
• Dynamo
• Starter Motor 
• Starter Motor Servicing
• Starter Motor Drive
• Adjustment of Rod Mechanism
• Starter Motor Switch
• Distributor
• Control Box
• Construction of the Ferguson Pre Engaged Starting Motor
• Lighting System
• Lighting System 6 Volt and 12 Volt
• Fitting and Drilling Instruction
• Main Harness
• Number Plate Bracket, Change Over Switch etc.
• Rear Flood Light and bracket
• Lighting Switch
• Wiring
• Bulbs 6 Volt and 12 Volt
• Clutch
• Description
• Pedal Adjustment
• Clutch removal
• Re-Facing the Clutch Driven Plate
• Adjustment of Release Levers
• Replacing Clutch Assembly
• Clutch Release Bearing
• Clutch Pilot Bearing
• Clutch for Diesel Engine Tractor TE-F20
• Transmission
• GEAR RATIOS
• Drive
• Selector Mechanism
• PREPARATION FOR DISMANTLING TRANSMISSION ASSEMBLY
• To Remove Steering Assembly
• To Remove Rear Axle Centre Housing from Transmission Housing
• TO DISMANTLE TRANSMISSION ASSEMBLY
• To Dismantle Countershaft Assembly
• To Build up Countershaft Assembly
• Removal and Replacement of Bearings and Gear
• TO RE-ASSEMBLE TRANSMISSION
• Replace Reverse Shaft Assembly
• Replace Countershaft Assembly
• TO REPLACE SHIFTER RAILS AND SELECTORS
• TO DISMANTLE GEARSHIFT LEVER ASSEMBLY
• To Build up Gearshift Lever Assembly
• To Replace Steering Assembly
• To Fit Rear Axle Centre Housing to Transmission Housing.
• Rear Axle and Hubs
• SPECIFICATION AND DATA
• CROWN WHEEL AND PINION
• CROWN WHEEL NUTS
• REAR AXLE AND HUBS
• Rear Axle Assembly
• To Remove Axle Shaft Assembly
• To Fit Axle Shaft Assembly
• To Dismantle Axle Shaft Assembly
• To Re-Build Axle Shaft Assembly
• To Remove Differential Assembly
• To Replace Differential Assembly
• To Dismantle Differential Assembly
• To Re-Build Differential Assembly
• To Remove Driving Pinion and Sleeve Assembly
• Replacement of Driving Pinion and Sleeve Assembly
• Pinion Bearing
• Thrust Bearings - Removal and Replacement
• Thrust Bearing Cups
• Pilot Bearing Removal and Replacement
• Hydraulic System and Linkage
• HYDRAULIC SYSTEM
• GENERAL DESCRIPTION
• PUMP DRIVE COUPLING
• FUNCTION OF THE HYDRAULIC PUMP
• CONTROL VALVE
• CONTROL VALVE BUSH
• ACTION OF THE PUMP
• CONTROL MECHANISM
• TO LOWER IMPLEMENT
• TO RAISE IMPLEMENT
• SAFETY DEVICE
• THE HAND CONTROL FORK
• TO REMOVE HYDRAULIC PUMP
• TO DISMANTLE HYDRAULIC PUMP
• TO REMOVE AND REPLACE CONTROL VALVE BUSH
• TO RE-ASSEMBLE HYDRAULIC PUMP
• TO REPLACE HYDRAULIC PUMP
• TO REMOVE LIFT ASSEMBLY
• TO REPLACE LIFT ASSEMBLY
• TO REMOVE HYDRAULIC CYLINDER ASSEMBLY
• TO REPLACE HYDRAULIC CYLINDER ASSEMBLY
• TO REMOVE LIFT SHAFT
• TO REPLACE LIFT SHAFT
• TO DISMANTLE FORK MECHANISM
• CONTROL SPRING ASSEMBLY
• CONTROL SPRING ADJUSTMENT
• TO REMOVE AND DISMANTLE QUADRANT ASSEMBLY
• CONTROL LEVER ADJUSTMENT
• FRICTION DISC ADJUSTMENT
• LINKAGE
• LOWER LINKS
• CHECK CHAINS
• LIFT RODS
• UPPER LINK
• RACK
• LUBRICATION
• TO DISMANTLE AND RE-ASSEMBLE LEVELLING
• LEVER ASSEMBLY
• DRAWBAR
• HYDRAULIC FAULT TABLE
• HYDRAULIC SYSTEM
• OSCILLATING CONTROL VALVE
• TO REMOVE AND DISMANTLE HYDRAULIC PUMP
• TO DISMANTLE AND RE-ASSEMBLE OSCILLATING VALVE
• TO RE-ASSEMBLE HYDRAULIC PUMP
• TO REPLACE HYDRAULIC PUMP
• LEVELLING LEVER ASSEMBLY
• HYDRAULIC TAPPING POINTS
• VALVE CHAMBERS
• UPPER LINK
• QUADRANT ASSEMBLY - DIESEL TRACTORS
• TO REMOVE QUADRANT ASSEMBLY
• TO DISMANTLE QUADRANT ASSEMBLY
• TO REPLACE QUADRANT ASSEMBLY
• HYDRAULIC LIFT COVER AND CYLINDER ASSEMBLY
• CONTROL VALVE BUSH REMOVER
• CONTROL SPRING ROCKER BUSH
• TO REMOVE CONTROL SPRINGROCKER BUSH
• TO REPLACE CONTROL SPRING ROCKER BUSH
• HYDRAULIC FORK SPREADER
• HYDRAULIC SYSTEM AND LINKAGE
• FAULT TABLE
• Power Take Off Shaft
• POWER TAKE-OFF SHAFT
• To Remove P.T.0. Shaft
• To Replace P.T.O. Shaft
• P.T.O. Shaft Rear Bearing Assembly
• To Dismantle Rear Bearing Assembly
• To Build Up Rear Bearing Assembly
• P.T.0. Shaft Coupling
• To Dismantle the P.T.O. Shaft Coupling Assembly
• P.T.O. Shaft Front Bearing Assembly
• To Remove P.T.O. Shaft Front Bearing
• To Replace P.T.O. Shaft Front Bearing
• Steering Gear
• DESCRIPTION
• UPPER ASSEMBLY
• To Remove
• To Replace
• To Dismantle
• To Assemble
• STEERING HOUSING ASSEMBLY
• To Remove Complete
• To Replace
• To Remove Sectors
• To Replace Sectors
• Front Axle Assembly
• FRONT AXLE ASSEMBLY
• Centre Trunnion
• To Remove Centre Beam
• Radius Rods
• Steering Drag Links
• Removal of Front Axle Assembly
• SPINDLE ASSEMBLY
• To Remove
• To Replace
• Spindle Bushes
• To Remove
• To Fit
• FRONT HUBS
• To Dismantle
• To Assemble
• SETTINGS AND ADJUSTMENTS
• Brakes
• GENERAL
• PRINCIPLE-FLOATING CAM TYPE BRAKES
• ADJUSTMENTS - BOTH TYPES
• MAINTENANCE
• SERVICING
• BRAKE LININGS
• KIDNEY-CAM OPERATED TYPE
• FLOATING-CAM OPERATED TYPE
• RECONDITIONING BRAKES
• KIDNEY-CAM OPERATED TYPE FLOATING CAM TYPE
• RESETTING SHOES - KIDNEY CAM AND FLOATING
• CAM OPERATED TYPES
• RE-CONNECTING LINKAGE
• BRAKE FAULT TABLE
• Wheels and Tires
• FITTING TYRES
  
• REMOVING TYRES
• TRACK WIDTH ADJUSTMENT
  
• STEEL WHEELS
• WHEEL GIRDLES
• Fitting
• Adjustment
• Seat, Hood and Fenders

File Format: PDF 

Language: English 

Print: Print the complete manual or just the pages you require  

Bookmarked: Bookmarked for easy navigation

Requirements: We recommend using Adobe PDF Reader for best results 

Device: We recommend downloading to a PC or Laptop or visit our Download Help Page for further information regarding Smart Devices

Images are Copyright©Car Manuals Direct and are used for promotional purposes only.

Copyright©Car Manuals Direct 2018